Pendleton County · Falmouth, KY

Falmouth Commercial Roofing Contractor

Move Heavy Rain Off Low Roof Sections Before It Finds the Ceiling

As a Falmouth commercial roofing contractor, we replace and repair roofs with drains, scuppers, and flashing sized for the heavy rain this river town sees.

Roofer working on a black EPDM rubber membrane on a commercial roof
  1. Inspect Your Roof
  2. Core Cuts And Readings
  3. Written Scope
  4. Free Estimate

Drainage First With a Falmouth Commercial Roofing Contractor

A Falmouth commercial roofing contractor starts with where the water goes, because heavy rain on low roof sections finds every weak detail.

Low commercial roof section torn off down to the deck for new drainage

Falmouth, the Pendleton County seat, grew up where the Licking River meets its South Fork, and low-lying blocks have flooded in the past. Roofs there need drains and scuppers sized for heavy rain, plus curbs and flashing raised above the water that collects on low sections.

Commercial roof work in Falmouth is permitted through the Kentucky Department of Housing, Buildings and Construction, since the state sheet for Pendleton County lists no local building inspector. City hall can confirm any added local steps.

  • State DHBC permits for commercial work
  • Drains and overflow scuppers sized for heavy rain
  • Raised curbs on low roof sections

Commercial Roofing Conditions in Falmouth

Water is the theme on Falmouth roofs. These are the places it gets in.

  • Watch
  • Repair First
  • Call Now
  1. Scuppers Too Small for Storms

    Repair First

    Narrow scuppers back water up behind the parapet during a heavy downpour.

  2. No Overflow Beside the Drain

    Call Now

    A single clogged drain on a low section fills the roof with nowhere else for water to go.

  3. Curbs Sitting in Water

    Repair First

    Short curbs on low sections keep their base flashing wet, and leaks start at the corners.

  4. Silt in Gutters and Downspouts

    Watch

    Silt and debris pack gutters on low edges and send water over the side onto walls.

  5. Wet Insulation at Step-Downs

    Watch

    Where an upper roof drains onto a lower one, insulation below the outlet stays soaked.

Benefits of a New Commercial Roof

Bigger drains and higher flashing protect a Falmouth building from the rain that matters most.

Owner

  • Overflow scuppers next to each drain give heavy rain a second way off the roof.
  • Raised curbs and flashing keep the edges of rooftop units above collecting water.
  • State permit review up front keeps the commercial job moving without a stop order.

Facility Manager

  • Gutters and downspouts sized for heavy rain stop spilling over the low edge.
  • Strainers on each drain catch silt and leaves before they block the outlet.
  • Splash pads under upper-roof outlets protect the lower membrane from wear.

Tenants And Staff

  • Ceilings under the low sections stop staining once water leaves the roof quickly.
  • Walls below the eave stay dry when gutters are cleared and resized.
  • Work closes each section watertight before the crew leaves the roof.

Commercial Roofing Options for Falmouth

Roof drains sized for heavy rain anchor every option. The membrane depends on the building.

Commercial Roofing Options for Falmouth
OptionWhere It FitsWhat Gets Checked First
Drain and Scupper UpgradeDry roofs that back up in stormsOutlet sizes against the roof area
EPDM Over Tapered BoardsLow sections crowded with pipesWet insulation near the outlets
TPO ReplacementOpen low-slope roofs on shops and officesDeck condition and edge heights
Curb and Flashing RaiseUnits sitting low on wet sectionsBase flashing height and curb wood

Roof Backing Up in Heavy Rain?

Water through a Falmouth ceiling during a storm gets a call. A roof that backs up every downpour gets a drain review and a plan for bigger outlets.

Leaking Now?

Water inside during a storm

Call Us

Planning Roof Work?

Bigger drains or a new roof

Get A Free Estimate

Top Commercial Roofing Drain Upgrades in Falmouth

Overflow scuppers on a flat roof, bigger drains, and raised curbs go in during a four-step job.

  1. Inspect Your Roof

    Drains, scuppers, gutters, and curbs are measured, and water marks show how high it rises in storms. Core cuts check insulation near outlets.

    Roofer checking drains and scuppers on a low commercial roof
  2. File With the State Office

    Commercial roof permits go to the Kentucky Department of Housing, Buildings and Construction, and city hall confirms any local steps.

  3. Resize the Outlets

    Drain bowls get new rings and strainers, scuppers are widened and relined, and overflow outlets go in beside each primary drain.

    Roofing truck with drain and scupper materials beside a building
  4. Raise and Flash

    Curbs on low sections are raised, new membrane runs up each one, and gutters and downspouts are cleared and resized.

Commercial Roofing

Find Your Town

Is your building somewhere other than Falmouth? We repair and replace commercial roofs in these towns; for anywhere else, call us or send us a message.

  • Alexandria

    Campbell County storefront and office roofs.

  • Crittenden

    Pitched metal conversions over old flat roofs.

  • Dry Ridge

    Kitchen and lodging roofs at the interchange.

  • Independence

    Full commercial roofing service across Kenton County.

  • Walton

    Boone County roofs with long membrane runs.

Falmouth Commercial Roof Questions

Answers for building owners in Falmouth and across Pendleton County.

Permits

Who handles commercial roof permits in Falmouth, KY?

Commercial construction in Falmouth is permitted through the Kentucky Department of Housing, Buildings and Construction, because the state sheet for Pendleton County leaves the local inspector line empty. Falmouth city hall can confirm added local requirements, and the county inspections page covers electrical work on rooftop units.

Does a drain upgrade need a permit?

Adding drains or scuppers, raising curbs, or replacing the roof all count as commercial roof work. Ask the state office before work starts, with the roof area, the new outlets, and any rooftop unit changes listed.

Drainage

How big should roof drains and scuppers be?

Outlet size follows the roof area each drain serves and the rainfall the design is built for. During a replacement, existing drains are checked against that area, and overflow drains or scuppers go in where only primary drains exist.

How are gutters and downspouts handled on low roof edges?

Gutters on the low edge get checked for size and condition during any roof job. Silt and debris are cleared, undersized gutters are replaced with larger ones, and downspouts are routed so water lands away from doors and foundation walls. Hangers are reset where snow or ice bent them.

Why add overflow scuppers on a flat roof?

A primary drain can clog with leaves or silt in the middle of a storm. An overflow scupper set a little higher lets water leave through the parapet before it rises over curbs and flashing.

Low Sections

Why do rooftop units leak on low roof sections?

Short curbs sit in water that collects on low sections, so their base flashing stays wet and splits at the corners. Raising the curb and running new membrane up it keeps the joint above standing water.

What happens where an upper roof drains onto a lower one?

Water pouring from an upper outlet wears the lower membrane and soaks the insulation beneath it. A splash pad under the outlet and a check of the insulation there are part of any replacement.

Talk With a Falmouth Commercial Roofing Contractor

Tell us where water backs up in heavy rain. We will measure the drains and plan outlets that keep up.

Call Us (859) 204-8370